Direct To Tire / Pour In Installation

This is the most common method for dealers and those who own their own tire changers.

Coat only the tire, not the rim, with small amount of bead lube.

We realize this picture is for a different installation than the one below, but the importance of this procedure is too important to leave it out. Also do not use Tire Changers that automatically coat the rim with mounting grease. Wipe the excess from the swab before applying to tire so none drips inside.

Gently work the first tire bead down over the rim

Cut the bag, lift the top edge of the tire, and pour the beads into the tire.

Press down on the opposite side while the changer installs the second tire bead.

This is important: Stand the tire up with the valve stem at the top as shown.

Apply the air to seat both tire beads onto the rim.

You're good to go!